Skip to content

Measuring Progress Without a Coach

November 19, 2026
·
4 min read

A coach measures you the same way each time, remembers what you did last month and notices when you are working harder than you think. Alone, you need a small system that does those three jobs. A phone, a tape measure and a notebook are enough.

Make every test a fair test

A test is only useful if you can compare it with the last one, so keep the venue, surface, shoes, warm-up, time of day and timing method the same each time. Note the wind and weather too: a headwind alone can slow a sprint.

Tests with a phone stopwatch

For running, the simplest tests are time trials over a fixed distance, such as one lap of the track, 1 mile or 3 km. Use the lap button each time you pass the line. Over these distances, a small timing error hardly matters.

Short sprints are harder to time alone, because any error is large compared with the time itself. Two options work well:

  1. Ask a friend to start the watch on your first movement and stop it as your chest crosses the line.
  2. Film the run from the infield, far enough back to see the start and the finish, then step through the video from your first movement to the line.

Pick one method and stick with it, since hand and video times do not compare.

Tests with a tape measure

  • Standing long jump: toes behind a line, jump with both feet and measure to the back of the nearest heel. Best of three, with full rest.
  • Standing throws: measure from the inside edge of the circle or throwing line to the first mark the implement makes. Only where the venue allows throwing and the sector is clear.

Anchor the zero end of the tape with a peg or a heavy shoe so you can measure on your own.

Keep a training log

Paper or a note on your phone both work. Keep each entry to a few lines, written within an hour of training:

  • The date and which session you did
  • What you actually did, including anything you changed or cut
  • Key times, distances or reps
  • Your RPE for the session
  • Sleep, stress and weather, in a word or two
  • Anything that felt wrong

Once a week, spend five minutes reading back over the last seven days.

Use RPE

RPE, or rate of perceived exertion, is how hard something felt on a scale from 1 to 10. Roughly: 1 to 3 is easy, 4 to 6 is steady, 7 to 8 is hard and 9 to 10 is close to everything you have. Rate each hard rep and the session as a whole.

RPE is most useful when you pair it with numbers. If the same 200 m in the same time now feels like a 6 instead of an 8, that is progress, even if the clock has not moved. If an easy run you know well suddenly feels like a 7, something is affecting you.

How often to test

Formal tests belong at the start and end of a plan, and perhaps once in the middle. Testing every week turns training into testing, and tired tests mislead you. Test when you are fresh, after a couple of easier days, and never the day after a hard session. A Veloce Acad plan writes out its start and finish tests step by step, so both numbers are measured the same way.

How to read a bad day

One poor session is information, not a verdict. First check the log for an obvious cause: short sleep, a stressful week, heat, wind or a hard session the day before.

  • One bad day: note it and carry on.
  • Two or three in a row: take a few easier days, then look again.
  • A pattern over two weeks or more: you may be doing more than your life allows right now, and an easier plan may suit you better.

If a test goes badly in poor conditions, retest once a few days later and record both results. Pain is different from a bad day: it is a reason to stop and see a health professional.

Progress also shows up in quieter ways: smoother technique, a lower RPE at familiar paces, and simply completing more sessions. Write those down too.

Train with a plan.

Six disciplines, three levels, one payment.